X-Git-Url: http://dxcluster.net/gitweb/gitweb.cgi?a=blobdiff_plain;f=cmd%2FCommands_en.hlp;h=463d55e8800766b2d9716de66c3ff70accd963bd;hb=952bc2f3d0ec7c7aa441ade9e75647a8e41270a1;hp=257e171397316a94bb95cf4a895f61d9393ac678;hpb=68d8a8f62c229b470cf341d0347a89f56aa6531b;p=spider.git diff --git a/cmd/Commands_en.hlp b/cmd/Commands_en.hlp index 257e1713..463d55e8 100644 --- a/cmd/Commands_en.hlp +++ b/cmd/Commands_en.hlp @@ -695,11 +695,6 @@ etc). eg:- or pc G1TLH Try doing that properly!!! -=== 1^PING ^Send a ping command to another cluster -This command is used to estimate the quality of the link to another cluster. -The time returned is the length of time taken for a PC51 to go to another -cluster and be returned. - === 0^KILL [ ...]^Remove or erase a message from the system You can get rid of any message to or originating from your callsign using this command. You can remove more than one message at a time. @@ -720,10 +715,11 @@ PC protocol to connected nodes either for testing or to unstick things. You can also use in the same way as a talk command to a connected user but without any processing, added of "from to ^Find out the delays an a circuit to another node -This command will enable sysops to determine the speed of an inter-cluster -node. - +=== 1^PING ^Check the link quality between nodes +This command allows you to send a frame to another cluster node on +the network and get a return frame. The time it takes to do this +is a good indication of the quality of the link. The actual time +it takes is output to the console in seconds. Any visible cluster node can be PINGed. === 1^RCMD ^Send a command to another DX Cluster @@ -1353,7 +1349,7 @@ is provided for users of this software by http://www.qrz.com === 0^SHOW/ROUTE ...^Show the route to the callsign This command allows you to see which node the callsigns specified are -connected via. It is a sort of inverse sh/config. +connected. It is a sort of inverse sh/config. sh/route n2tly