X-Git-Url: http://dxcluster.net/gitweb/gitweb.cgi?a=blobdiff_plain;f=cmd%2FCommands_en.hlp;h=1cd2b30f664ff0087f2b66b97b19cecd01400ee3;hb=e9c1322080e18fb8f6f3f0e54bfcbdf3f4da3909;hp=8ab9b000c661172dbcdc01954a0351229b257413;hpb=4a653ce0cd9140d4a7878cdf8ee835841ca039eb;p=spider.git diff --git a/cmd/Commands_en.hlp b/cmd/Commands_en.hlp index 8ab9b000..1cd2b30f 100644 --- a/cmd/Commands_en.hlp +++ b/cmd/Commands_en.hlp @@ -1053,6 +1053,10 @@ If a ping is heard then the obscount is reset to the full value. Using default values, if a node has not responded to a ping within 15 minutes, it is disconnected. +You can set this parameter between 1 and 9. + +It is STRONGLY recommended that you don't change the default. + === 0^SET/PAGE ^Set the lines per page Tell the system how many lines you wish on a page when the number of line of output from a command is more than this. The default is 20. Setting it @@ -1069,13 +1073,29 @@ affect routing decisions. The default interval is 300 secs or 5 minutes. You can use this command to set a different interval. Please don't. -But if you do the value you enter is treated as minutes up 60 and seconds +But if you do the value you enter is treated as minutes up 30 and seconds for numbers greater than that. This is used also to help determine when a link is down at the far end (as certain cluster software doesn't always notice), see SET/OBSCOUNT for more information. +If you must change it (and it may be useful for internet connected nodes +on dynamic IP addresses that go away after a set time of usage) the time +can be specified as:- + + 5 which if less than 30 is converted to minutes otherwise is + taken as the no of seconds between pings. + 120s 120 seconds + 5m 5 minutes + 1h 1 hour + +Please be aware that this causes traffic to occur on the link, setting +this value too low may annoy your neighbours beyond the point of +endurance! + +You can switch this off by setting it to 0. + === 9^SET/PRIVILEGE [